Shingles: Organic or asphalt, fibreglass – 3-tab, architectural

•  Visually inspect and fix small defects such as tears, cracks or mechanical damage
•  Seal exposed nail heads
•  Ensure starter shingles on hips & ridges are sealed
•  Tap down pop-ups and under-driven nails & apply a sealant to lifted shingles (Max. 30 shingles included)
•  Replace up to five missing shingles where applicable and/or provide a temporary solution to ensure that water doesn’t get in

Please advise at time of booking if shingles are missing. We will replace up to 5 shingles dependant on colour & style availability. If a product has been discontinued, we will provide suggestions & estimates for alternatives.

Gooseneck Flashings: Exhaust fans

• Visually inspect for cracks on goosenecks and surrounding area; seal where needed
• Replace under-driven nails with roofing screws, adding extra where necessary
• Caulk any cracks or openings around the goosenecks
• Locate and remove bird nests
• Seal exposed nailheads

Attic Vents: and other roof venting

• Visually inspect for cracks on vent and surrounding area; seal where needed
• Replace under-driven nails with roofing screws, adding extra where necessary
• Caulk any shingle cracks/openings around vents
• Locate and remove bird nests
• Determine if quantity and placement of attic vents seems sufficient; provide recommendations if venting is inadequate
• Seal exposed nailheads

Plumbing Flashings

• Inspect rubber boots for cracks; apply sealant as needed
• Remove under-driven nails and replace with roofing screws
• Apply sealant around rubber collar
• Seal exposed nailheads

Metal Wall Flashings

• Replace under-driven nails with roofing screws
• Add roofing screws to close any gaps under flashings
• Caulk lap joints if overlaps are less than 4”, seal holes

Metal Valley Flashings

• Inspect for cracks and repair by cleaning surface with solvent and applying sealant

Skylights

• Verify if skylight unit is properly secured to frame; refasten if needed
• Inspect acrylic (plastic) or glazing (glass) for cracks; seal if required and provide recommendations for care or replacement
• Inspect metal back pans, aprons, step & counter flashings; reseal & refasten where required
• Seal exposed fasteners and add screws where needed

Chimneys

• Inspect chimney stack storm collar and seal if needed
• Inspect metal rain caps and refasten if loose
• Verify whether the metal cap flashing is fastened correctly; add roofing screws as required
• Inspect siding on chimney walls and seal any gaps as needed
• Locate and fill small cracks on cap or walls of masonry or stucco chimneys